QNAP TVS-472XT 4-Bay NAS Enclosure - Manual (Page 357)

Enabling T2E on macOS
1. Open the Terminal.
2. Run the command.
Command Notes
sudosysctlnet.inet.tcp.path_mtu_discovery=0 &&
sudosysctlnet.inet.tcp.tso=0
This command will only temporarily enable T2E.
Restarting the Mac will delete the connection.
sudo bash –c ‘printf
“#QNAP\nnet.inet.tcp.path_mtu_discovery=0\nnet.in
et.tcp.tso=0\n#QNAP\n” >> /etc/sysctl.conf’
This command will permanently apply these
settings.
Virtual Switches
This screen controls the configuration and management of virtual switches running on the NAS. Virtual
Switches allow physical interfaces and virtual adapters to communicate with each other.
QTS supports three different virtual switch modes.
Mode Description
Basic This mode is well-suited for most users, and requires
minimal configuration of network settings.
Advanced This mode is best-suited for power-users who need
more control over the configuration of network
settings.
QTS 4.4.x User Guide
Network & Virtual Switch 356