Daktronics OmniSport 2000 Timing Console - Manual (Page 94)

76 OmniSport 2000 Pro Swimming Software
 The Primary Time options tell the timer to use the Touchpads, Button 1, or Buttons 1-3
for primary event split and finish times. The touchpad is the typical selection.
 The Lane Module Input options configure the timer for touchpads and push buttons at
the Near end only, or both Near/Far ends of the pool.
 The Precision options set the timer to store and print times depending on whether
times are displayed to 1/100 or 1/1000 of a second.
Note: 1/100 will show two decimal places, while 1/1000 will show three.
 The Relay Take-off Platforms options allow the operator to select the Type from None,
Button/Daktronics, or Omega Platform and the Input (Button 1-3) used for relay
exchanges. It’s also possible to select the Arm Time of the input from 0.1–1.5 seconds.
Click OK when finished to save the data, Cancel to exit, or select another tab.
Console Printer
The Console Printer tab (Figure 88) configures the console’s built-in printer settings.
Each setting is described below:
 Print Results enables the console printer to print the results of the event.
 Race Log enables the console printer to print the race log of the event. To view a saved
Race Log, exit the Configure window and go to File > Open Log.
 Results determines how the results will be printed: by Lane or by Place.
 Print Backups enables the console printer to print the backup times of the event.
 Print Splits enables the console printer to print splits of the event.
o
Select No to disable this option.
o Select Cumulative to print the split times as a cumulative time.
(Example: Lap1 0:58.32, Lap2 1:57.68, Lap3 2:57.39)
o Select Subtractive to print the split times as single lap times
(Example: Lap1 0:58.32, Lap2 0:59.36, Lap3 0:59.71)
 Select the Number of Copies to print, up to 5.
Click OK when finished to save the data, Cancel to exit, or select another tab.
Figure 88: Console Printer Configurations