Daktronics OmniSport 2000 Timing Console - Manual (Page 306)

254 Console & Software Revision History
Version 12.3.20 – Release date: 20 March 2012
Swimming
 Reduced the ARM TIME for Relay Take-off Platform (RTOP) to a maximum 1.5
seconds.
 Made adjustment to the ARM TIME window for the RTOP.
Version 12.12.20 – Release date: 20 December 2012
General
 Added test routines for beeper volume, network jack, audio jack, and smart start.
 Added setting default IP address and subnet mask in test routines.
 Added an additional printer dot advance in print line routine, to fix a problem with
newer version(5.75) printers because they would not print a line after receiving 21
characters.
Swimming, Diving, Pace Clock, Synchronized Swimming, Water Polo, Track
 Added menu setting for the beeper volume.
 Added menu for setting network IP address.
 Added menu for setting network subnet mask.
 Added menu for setting network gateway address.
 Added menu for setting network socket number.
 Added menu for viewing network MAC address.
 Added data output on network for RTD.
Version 13.03.26 – Release date: 26 March 2013
General
 Made additions to make sure that old boards did not have Ethernet enable flag set,
which would cause them to lock up when requesting a start list.
Version 13.07.18 – Release date: 18 July 2013
General
 Changed the printer intensity levels to lower values for each setting.
 Added “NTWK” error message on the 3rd LCD if network enabled and no network
detected.
Swimming, Diving
 Added communication with Pro Swim over the network.
 Added communication with MEET MANAGER over the network.
 Added selection of Omni ID at start up, with selection of Omni1 to Omni4.
 Added selection of standard and custom IP address settings, with standard set to
192.168.0.55 for Omni1, 192.168.0.56 for Omni2, 192.168.0.57 for Omni3, and
192.168.0.58 for Omni4.
 Added selection of standard and custom RTD Port # settings, with the standard set
to 3002 for Galaxy and for DVX/N it is 21000 for Omni1, 21001 for Omni2, 21002 for
Omni3, 21003 for Omni4.
 Added update of lane status sent to Pro when # of Lanes or Lane order is changed.
 Changed how backup times are calculated, removed the rounding that was in the
calculation.
 Added the display of the Omni name selected on the 3 rd LCD.
 Changed to set the Event and Heat to the first event after a download of the Event
order.
 Fixed so the start list is requested after the event download.
 Added send of updated lane status after reverse lane order and near/far touchpad
setup from Pro.