Daktronics OmniSport 2000 Timing Console - Manual (Page 65)

Swimming Mode Menus & Settings 47
MENU-PRI NT
2-EVENT ORDER
MENU-PRI NT
3-SETTI NGS
To print a stored race, press the [0]-[9]
keys to enter the desired race number
and press [ENTER]. The LCD will then
prompt the operator to verify the entered
race number. Press [YES] to print the
selected results (Figure 66). Refer to
Section 4.10 for more printout samples.
Press [NO] to ignore the selection and
return to the Print Menu.
If the desired race has been deleted from
the console’s memory, the LCD will
quickly flash RACE NOT FOUND.
When to use this:
 Use this to re-print a race result on the console’s built-in thermal printer.
Print Event Order
This menu is used to print the event order.
Press [YES] to print the event order. Press [NO] to exit the menu without printing.
When to use this:
 It is a good idea to print out an event order before starting each session to verify that
the console is expecting to time the events in the desired order.
Print Settings
This menu is used to print the console’s configuration.
Press [YES] to print the settings. Press [NO] to exit the menu without printing.
Figure 66: Race Printout Samples
From Main Menu – [3]>[1]
From Main Menu – [3]>[3]
From Main Menu – [3]>[2]
PRI NT RESULTS
RACE NUMBER 772*
PRI NT RESULTS
PRI NT #772 Y/N
PRI NT RESULTS
RACE NOT FOUND
MENU-PRI NT
PRI NT ORDER? Y/N
MENU-PRI NT
PRI NT SETTI NGS?