7 timer operations after race, Store print, 8 printouts from the built-in printer – Daktronics OmniSport 2000 Timing Console User Manual
Page 209: Track configurations, Results printouts, Timer operations after race, Printouts from the built-in printer
Track Mode Operation
191
14.7 Timer Operations After Race
This section describes operations that must take place after an event has completed. Doing
these operations will increase the effectiveness of accurate timing and help ease the flow of
running a large track meet.
Store Print
If an error is observed on the printout, press [EDIT]. Press [STORE PRINT] to verify the
correction. After all corrections are made, press [RESET]>[ENTER]. Refer to Section 15.4.
The timer is now ready to begin the next event. Advance to the next event or heat and
continue. Follow the steps in Sections 14.5 and 14.6 through each race.
14.8 Printouts from the Built-in Printer
This section illustrates typical printouts from the OmniSport
2000 console. To create a printout from the console’s built-in
printer, refer to Section 15.4.
Track Configurations
It is important to save the printout (Figure 194) for system
settings to reuse for future meets. The basis of the settings is
letting the console know how the physical track and timer
are configured.
Results Printouts
Figure 195 illustrates a typical printout for an eight-lane
track showing Lane and Place results for two heats.
Figure 194: Typical Track Settings
Figure 195: Typical Track Results Printout