Daktronics OmniSport 2000 Timing Console - Manual (Page 92)

74 OmniSport 2000 Pro Swimming Software
Test
The Test tab (Figure 85) is used to test the battery, display, lane modules, and touchpads.
 The Battery field displays the power source and the power level of that supply.
 The Lane Modules field displays which touchpad or backup button is being activated.
An X indicates the lane being tested if the equipment is working properly. It is
possible to enable and disable certain devices and lanes by clicking the appropriately
labeled buttons. This test procedure requires at least two people; one to monitor the
system and another to activate the input devices.
If there is only one person available, click Lane Module Test Mode, then turn the
computer monitor so it can be seen from the touchpads and lane modules. Go to the
input devices and active them. The monitor will display the activated device so that
it can be seen from the poolside.
 The Scoreboard section contains three buttons for testing the scoreboard:
o
Cycle On/Off: Click to send an all on signal to the scoreboard approximately
every 3 seconds until deselected.
o Show Address: Click to display the driver addresses. The number or letter will
show which output on the driver that digit is plugged into.
o Show Digit: Click to confirm the digits are operational and properly plugged at
the time of installation and if the system needs debugging.
6.8 Pro Configuration
Configuring the Pro Swimming software is important for managing swimming events.
To access the Pro configuration, go to Options > Configure on the main application screen.
Much of this information pertains to both the OmniSport 2000 Pro software and the
OmniSport 2000 console. For information about the equivalent console settings listed in this
section, refer to Section 5.
Pool
The Pool tab (Figure 86) configures the OmniSport 2000 Pro software to the particular pool
being used.
Figure 85: Test Tab