Daktronics OmniSport 2000 Timing Console - Manual (Page 52)

34 Swimming Mode Operation
Near End and Far End Touchpad Status
Near End Touchpad Status and Lengths Completed
Lengths Completed and Far End Touchpad Status
Watch for Accurate Lane Status
Watch swimmers as they touch for splits or finish a race to verify that the correct lane status
is showing. Refer to Section 4.2 to interpret the symbols on the LCDs.
Manual Touch Commands
If necessary, add or subtract touches if swimmers miss the touchpad or have extra touches.
Press [+ TOUCH] or [- TOUCH] then [LANE ON/OFF] at any time during a race to adjust
the length count for an individual lane. Another method is to press [+ TOUCH] or
[- TOUCH], and use the numeric keypad to input the lane number followed by [ENTER].
This would normally be done to keep the timer’s internal length count correct if a split time
was missed. Press [CLEAR] to cancel the action any time.
Note: Manual times are marked with a +/- on printouts to distinguish them from normal
touchpad times.
Start
The timer operator watches running time to verify start was received. The timer starts
automatically when the horn start triggers the start of the race. Be prepared to manually start
by pressing [START] if the timer does not start automatically with the horn start’s flash and
tone. If this occurs, the timer operator must notify the meet starter and the meet referee.
The timer will start any time a start impulse is received. Pressing [START] may also be used
to start the timer. The printer notes if the start is External or Keyboard.
The OmniSport 2000 console has an internal time-of-day clock that continually runs when the
timer is turned on which allows the always-ready-start feature. The internal clock runs even
when the race clock is stopped.
4 5 + 6 2
4 4 2 5 1 3 7 * * +
2 * * * * 01:37.6
011 03 P 08
+ 4 + * *
3 4 3 6 7  + 7 + * *
5 4 4 4 3  01:37.6
011 03 P 08
3 4 3 5 7 
4 + 2 * O  5 4 4 4 3 
* + + + + 01:37.6
011 03 P 08