Daktronics OmniSport 2000 Timing Console - Manual (Page 197)

Water Polo Mode Operation, Menus & Settings 179
MENU-COMM PORTS
2-RTD PORT
MENU-COMM PORTS
3-RESULTS PORT
MENU-SETUP
4-PRI NTER
MENU-PRI NTER
1-GAME LOG
RTD Port
Select RTD Port to assign a protocol, Real-Time Data (RTD)
or Colorado Timing System (CTS), to transmit out of the J5
RTD PORT on the console.
Use [←][→] to select RTD (default) to send information to a Daktronics display controller or
CTS to send to a numeric CTS scoreboard, and then press [ENTER] to save.
Results Port
Select Results Port to assign a protocol to transmit out of the
J6 RESULTS PORT on the console to communicate with
meet management software.
OmniSport 2000 (default) and OmniSport 6000 are bi-directional protocols. CTS is a
unidirectional protocol, utilizing the standard CTS scoreboard information.
Use [←][→] to select OMNI 2000, OMNI 6000, or CTS, depending on what the meet
management software is expecting to receive, and then press [ENTER] to save.
Note: If using an older version of Hy-Tek Meet Management, it may require configuring
this port to the OmniSport 6000 data. Selecting Omni 6000 transmits Omni 6000 RTD
item numbers on the RTD output.
13.13 Setup Printer Menu
Game Log
This menu is used to turn the game log printout ON or OFF.
If the Game Log is turned on, each time a clock is started, stopped, score +1, score -1, player
penalties, etc., the printout shows the time-of-day the action occurred. Use [←][→] to set the
Game Log ON or OFF, and then press [ENTER] to save.
From Main Menu – [3]>[3]>[2]
From Main Menu – [3]>[3]>[3]
From Main Menu – [3]>[4]
From Main Menu – [3]>[4]>[1]
MENU-COMM PORTS
RTD PORT: RTD* MENU-COMM PORTS
RTD PORT: CTS*
COMM PORTS
RSLT: OMNI 2000*
MENU-PRI NTER
GAME LOG: OFF*