Daktronics OmniSport 2000 Timing Console - Manual (Page 303)

Console & Software Revision History 251
Version 7.2.8 - Release date: 3 May 2007
Swimming
 Corrected problem where the middle button time was not always selected as the
backup time for three button backup timing when using a Daktronics RTOP and a
button in the same input.
Version 7.11.30 - Release date: 30 November 2007
Swimming
 Changed from printing a true zero (0) character to a capital ‘O’ character to avoid
confusion with an eight ‘8’ character.
 Added a Number of Copies configuration for the results printout.
 Added the ability to select an offset (0, 5k, 10k, 15k) for the RTD item number.
 Added the DQ status to the PLACE digit of a numeric scoreboard controlled by the
MULTIDROP protocol on the scoreboard outputs.
Water Polo
 Shifted the penalties for home and guest down a line on the 6 and 8 line setting for
the Multidrop, Multiline, Omega, and CTS scoreboard outputs.
 Added the ability to print a game log on the internal printer.
 Corrected a minor bug in the starting of a guest partial timeout.
Track
 Added address 19 to drive the second driver of the new football and soccer
scoreboards.
 Added the DQ status to the PLACE digit of a numeric scoreboard controlled by the
MULTIDROP protocol on the scoreboard outputs.
Version 8.3.7 - Release date: 20 March 2008
Swimming
 Added ability to record relay exchanges on far end for a 4x50 relay in a 50 Meter
pool.
Version 8.3.27 - Release date: 27 March 2008
Swimming
 Added a numeric value (0 or 1) to indicate the status of the logo at offset 1067 in the
RTD.
 Added support for the “Swap Order” button on the Current Race tab of the Pro
interface.
Track
 Added a value (0 or 1) to indicate the status of the logo at offset 1067 in the RTD.
Version 9.4.6 - Release date: 6 April 2009
General
 During the power up sequence of the timer, the proper format to enter the data is
shown for the initial DATE (mm/dd/yy) and TIME (hh:mm:ss) entry screens.
 Added support for a request from and transmission to the Pro application for the
version number of the program in the timer to help ensure compatibility.
 Added another check of the CTS pin in the write functions to the printer to prevent
an overrun condition during the transmission of data to the printer's internal buffer.
 Changed the print routines to send only a Line Feed (LF) character to terminate a line
on the printer. Sending a Carriage Return (CR) character prior to the LF was causing
compatibility issues with the latest version of the printer firmware (5.65 / 5.75).