Daktronics OmniSport 2000 Timing Console - Manual (Page 189)

Water Polo Mode Operation, Menus & Settings 171
Settings to Note
The Horn Control setting can be set so that the main clock horn and the shot time horn are
tied together so that when one sounds, they both sound, or they can be independent.
When the Shot=0 Control setting is set to On and the shot clock counts down to 0, the game
clock stops. If the Shot=0 Control setting is set to Off, the game time will not stop when the
shot time reaches 0. Refer to Section 13.9 to review or change this setting.
13.4 Pre-Game Operations
Complete the following steps before each game. Review Section 3 thoroughly before
beginning operations.
1. Set up and test the system. Turn on the timer. Enter the correct date and time. Then
select the proper sport operation.
2. Printout the consoles settings [MENU]>[2]>[1]>[ENTER] and verify they are correct.
Specifically review:
 Horn Control (Section 13.9)
 Shot=0 Control (Section 13.9)
 Default Time Set (Section 13.9)
 Auto Sequence (Section 13.9) is on or off. If the Auto Sequence is set to ON, the
console will:
a. Count Period 1 time down to zero.
b. Switch to Rest 1 time and start counting. Count down to zero.
c. Switch to Period 2 and reset time to period time. Wait for start.
d. Operator presses [START].
e. Count Period 2 time down to zero.
f. Switch to Rest 2 time and start counting down to zero.
g. Switch to Period 3 and reset time to period time. Wait for start.
h. Operator presses [START].
i. Count Period 3 time down to zero.
j. Switch to Rest 1 time and start counting down to zero.
k. Switch to Period 4 and reset to period time. Wait for start.
l. Operator presses [START].
m. Count Period 4 time down to zero.
n. Switch to Rest 2 time and start counting. Count down to zero.
o. Switch to Period 5 and reset to overtime. Wait for start.