Daktronics OmniSport 2000 Timing Console - Manual (Page 178)

160 Pace Clock Mode Operation, Menus & Settings
MENU-MAI N
5-TEST MENU
MENU-TEST
1-BATTERY
MENU-TEST
2-SCOREBOARD
SB TEST MENU
1-CYCLE ON/OFF
SB TEST MENU
2-DRI VER ADDRESS
SB TEST MENU
3-DI GI T NUMBER
11.15 Test Menu
The OmniSport 2000 timer is equipped with features that
test battery level and the numeric scoreboard. The
following submenus explain how to use each of these tests.
Battery Test
This menu checks the battery power level.
The battery level will show as CHARGED or LOW. Press [ENTER] to exit the menu.
Scoreboard Test
These menus check the numeric scoreboard drivers.
Cycle On/Off
This menu checks the signal to the scoreboard.
Press [1] to toggle the scoreboard ON and OFF. When this menu is selected, an all ON signal
is sent at intervals of approximately 3 seconds. Press [ENTER] to exit the menu.
Driver Address
This menu shows which addresses each of the drivers on
the scoreboard are set to. The address plugs were inserted
when the display was installed.
Press [2] to display the driver addresses. Press [ENTER] to exit the menu.
Digit Number
This menu displays the digit designation.
Press [3] to display a digit number. The number or letter will show which output on the
driver that digit is plugged into. Press [ENTER] to exit the menu.
From Main Menu – [5]
From Main Menu – [5]>[2]>[2]
From Main Menu – [5]>[2]
From Main Menu – [5]>[2]>[3]
From Main Menu – [5]>[1]
From Main Menu – [5]>[2]>[1]
BATTERY TEST
LEVEL= CHARGED BATTERY TEST
LEVEL= LOW
DI SPLAY ALL ON
ENTER TO EXI T
SHOWI NG ADDRESS
ENTER TO EXI T
SHOWI NG DI GI T #
ENTER TO EXI T