Daktronics OmniSport 2000 Timing Console - Manual (Page 198)

180 Water Polo Mode Operation, Menus & Settings
MENU-PRI NTER
2-I NTENSI TY
MENU-SETUP
5-TI ME OF DAY
MENU-SETUP
6-NETWORK
MENU-SETUP
1-NETWORK ENABLE
MENU-NETWORK
2-I P ADDRESS
Intensity
This menu sets the printer’s contrast for easy readability.
The typical level is set at 5.
Press the [1]-[5] keys to select a new intensity and press [ENTER] to save.
13.14 Setup Time-of-Day Menu
This menu is used to set the console’s date and time.
Press the [0]-[9] keys to enter the correct date and time and then press [ENTER] to save.
Press [CLEAR] twice to exit without saving and retain the previous time and date.
13.15 Setup Network Menu
This menu is used to configure various network settings for
outputting Real-Time Data (RTD) to displays.
Network Enable
This menu sets the ETHERNET jack output on or off. If the
jack is not needed, it can be turned OFF (default).
Use [←][→] to toggle between ON/OFF and then press [ENTER] to save.
Note: If this setting is set to OFF, all of the menus below will be disabled.
IP Address
This menu allows the operator to set or verify the IP address
of the console. The default setting is shown below.
From Main Menu – [3]>[5]
From Main Menu – [3]>[4]>[2]
PRI NT I NTENSI TY
LEVEL 1-5: 5*
DATE MM/DD/YY
TOD HH:MM:SS*
MENU-NETWORK
NETWORK: ON *
From Main Menu – [3]>[6]>[1]
MENU-NETWORK
NETWORK: OFF*
1-STD* 2-CUST
192.168. 0. 55
From Main Menu – [3]>[6]>[2]