Daktronics OmniSport 2000 Timing Console - Manual (Page 68)

50 Swimming Mode Menus & Settings
MENU-TI MER
2-LM I NPUT
MENU-TI MER
3-PRI MARY TI ME
MENU-TI MER
4-FLAG TI ME
Manufacturers of Horn Starts Type of Output(s)
Daktronics HS-200 N.O. and N.C.
Colorado Timing Systems N.O.
Omega N.C.
Lane Module Input
This menu tells the console if there are touchpads at the
near end only, or both ends of the pool.
If there are no touchpads at the far end of the pool, or if they are not plugged into the deck
cabling, this setting should be set to NEAR. If there are touchpads at both ends of the pool
and they are plugged into a deck plate or lane module, this should be set to BOTH.
Use [←][→] to toggle the setting from NEAR to BOTH and then press [ENTER] to save.
Primary Time
This menu will configure the console for which timing
input(s) to use as the primary time.
The console can be set to use the TOUCHPAD, BTNS 1, or BTNS 1-3. If the console is set to
use the buttons as the primary time:
 There is no back-up time.
 If the console is set to BTNS 1, that is the time.
 If the console is set to BTNS 1-3, the console will use and display the time when the
second button is received.
Use [←][→] to toggle the setting between TOUCHPAD, BTNS 1, or BTNS 1-3 and then press
[ENTER] to save.
Flag Time
This menu determines the time (Flag Time) used when the
touchpad is compared to the back-up time.
From Main Menu – [4]>[2]>[2]
From Main Menu – [4]>[2]>[3]
From Main Menu – [4]>[2]>[4]
MENU-TI MER
LM I NPUT: NEAR*
MENU-TI MER
I NPUT: TOUCHPAD*
MENU-TI MER
FLAG TI ME: 0.3*