Daktronics OmniSport 2000 Timing Console - Manual (Page 206)

188 Track Mode Operation
Event Heat
 Event +1: This function increments the event number by one.
 Heat +1: This function increments the heat number by one.
 Heat -1: This function decrements the heat number by one.
 Event Heat: Press [EVENT HEAT] to enter a particular event and heat number.
Place/Lane/Non-Lane Timing
 Lane Timing: Pressing [LANE TIMING] enables all lanes and buttons configured in
the system. When this is enabled, each lane has one to three push buttons that will
record when a racer finishes the race.
 Place Timing: Pressing [PLACE TIMING] enables all places and buttons configured
in the system. When this is enabled, each place has one to three buttons that will
record when a racer finishes the race.
 Non-Lane Timing: Pressing [NON-LANE TIMING] disables all of the buttons
except Lane 1, Button 1. The official should press the button for every competitor
finishing the race.
 Non-Lane Split Enable: [NON-LANE SPLIT ENABLE] uses the next button recorded
to calculate the cumulative and subtractive split for that last lap. The split time will be
printed and displayed on the scoreboard. The [NON-LANE SPLIT ENABLE] key
only works if the [NON-LANE TIMING] key has been pressed.
Reset
The timer is automatically reset when first turned on. The timer may be reset any time the
race clock is running by pressing [RESET]>[ENTER].
When a race is complete, the operator presses [RESET]>[ENTER] to reset the timer.
Note: If the operator has not pressed [STORE PRINT] before resetting the timer, pressing
[RESET] will store the race and print the results in addition to resetting the clock.
If the timer was not reset before the start of the next race, see Section 14.6 Always Ready Start.
Menu
Press [MENU] to access additional functions and setting in the console. Section 15 describes
the menus in track mode and how to navigate them.
Disqualification (DQ)
The DQ (disqualification) flag can be used to disqualify a racer with subsequent re-ranking
on printouts and on the scoreboard.
Typical operation: Press
[DQ] and [LANE ON/OFF] key for the desired lane, or enter the
lane number on the number keypad and press [ENTER]. Doing this sets the DQ flag for that
lane. The DQ operation should normally be done at the conclusion of the race, after the
officials have ruled on the situation that caused the athlete to be disqualified. On exit from
the DQ command, the scoreboard is automatically updated and any subsequent printouts
will show the revised placing.