Daktronics OmniSport 2000 Timing Console - Manual (Page 50)

32 Swimming Mode Operation
4.5 Typical Multiple-Line Scoreboards
Multiple-line scoreboards are any LANE, PLACE and TIME digit board that will display two
or more lanes of results at one time. If the scoreboard is big enough to show all of the lanes in
the pool at the same time, the console can be configured to show the results in lane order or
place order.
If there are more lanes in the pool than
the scoreboard can show, the console will
display the results in place order by
scrolling through the results one page at
a time. To configure how the OmniSport
2000 console should display information
on the scoreboard, see Section 5.7.
The normal multi-line display of timing
information is completely automatic and
does not require any operator input.
Figure 56 illustrates a three-line
scoreboard with a 6-lane pool. Figure 57
illustrates a six-line scoreboard with a
6-lane pool.
Start of Race
The scoreboard shows the running time
on the top line of the scoreboard and
blanks the remaining lines. The running
time counts up from 0.0. If the number of
lines on the scoreboard equals the
number of lanes in the pool, the operator
can select lane order or finish order. If
the number of scoreboard lines is less
than the number of lanes in the pool, the
results are forced to place order.
Split Times
Split times are shown in lane order (default) for each lane on the corresponding scoreboard
line. Split times are held for 15 seconds (default). If there are fewer lines on the scoreboard
than lanes in the pool, only the first place split is displayed. Final times will page according
to the number of lines set. These functions are configured in the Numeric Scoreboard Setup
Menu (refer to Section 5.7).
Final Time
Final times are displayed on the scoreboard until the next race begins.
Timer Reset
The scoreboard shows last race data until the start of the next race.
Figure 56: Sequence of a
3-Line Scoreboard with a
6-Lane Pool.
Figure 57: Sequence of a 6-
Line Scoreboard