Daktronics OmniSport 2000 Timing Console - Manual (Page 225)

Track Mode Menus & Settings 207
SB TEST MENU
2-DRI VER ADDRESS
MENU-TEST
4-SWI TCH
Scoreboard Test
These menus check the numeric scoreboard drivers.
Cycle On/Off
This menu checks the signal to the scoreboard.
Press [1] to toggle the scoreboard ON and OFF. When this menu is selected, an all ON signal
is sent at intervals of approximately 3 seconds. Press [ENTER] to exit the menu.
Driver Address
This menu shows which addresses each of the drivers on
the scoreboard are set to. The address plugs were inserted
when the display was installed.
Press [2] to display the driver addresses. Press [ENTER] to exit the menu.
Digit Number
This menu displays the digit designation.
Press [3] to display a digit number. The number or letter will show which output on the
driver that digit is plugged into. Press [ENTER] to exit the menu.
Switch
This menu checks the lane buttons port on the rear of the
console.
1 2 3 4 5 6 7 8 9 10
When pressing one of the push buttons that is plugged into the Track Button Interface,
a “C” will display in that lane on the left or middle LCD.
From Main Menu – [5]>[3>[1]
From Main Menu – [5]>[3]>[2]
From Main Menu – [5]>[3]>[3]
From Main Menu – [5]>[4]
From Main Menu – [5]>[3]
MENU-TEST
3-SCOREBOARD
SB TEST MENU
1-CYCLE ON/OFF
DI SPLAY ALL ON
ENTER TO EXI T
SHOWI NG ADDRESS
ENTER TO EXI T
SB TEST MENU
3-DI GI T NUMBER
SHOWI NG DI GI T #
ENTER TO EXI T
C O O O O O O O TEST-SWI TCH
C-CLOSED O-OPEN