Daktronics OmniSport 2000 Timing Console - Manual (Page 48)

30 Swimming Mode Operation
DI SQUALI FY (DQ)
LANE NUMBER:10
1 2 3 4 5 6 7 8 9 10
The top line of the left and middle LCDs display the current lane status. An arrow by the lane
also indicates which lane is currently selected for editing. The following table defines what
each symbol means.
Symbol Definition
^
There is an error in the lane and the data needs to be edited.
DQ Indicates the person in the lane has been disqualified.
E Indicates an edited time.
-- Lane has been turned off.
OK All data is correct.
The bottom line of the left LCD shows the lane and time, and the center LCD shows the
backup time. The right LCD shows the options available for editing the lane times. Press [1]
to skip to the next lane. Press [2] to use the backup time. Press [3] to edit the lanes time. Press
[4] to turn the lane ON/OFF.
Disqualification (DQ)
Before the meet, the timing operator should clarify with the meet referee if he/she wants the
swimmers to be disqualified on the timer. Clarification of this is important for results to be
properly ranked on the printouts and meet management software which will show as a DQ
on the scoreboard.
Press [DQ] (disqualification) and [LANE ON/OFF] for the desired lane (or press the lane
number on the numeric keypad) and press [ENTER]. The DQ operation is normally done at
the conclusion of the race, after the officials have ruled on the situation that caused the
swimmer to be disqualified. On exit from the DQ command, the scoreboard is automatically
updated and any subsequent printouts will show the revised placing. The DQ operation
shown on the right LCD as illustrated, can be done at any point in the race and does not affect
arming or recording of times for the lane. Press the same
lane number again while in the DQ command to re-qualify
the swimmer and the original status indicator is returned.
OK OK 00 -- E
LN 6 0.00* ^[OK OK E OK
BACKUP-- 0:00.00 1-SKI P 2-BACKUP
3-EDI T 4-ON/OFF