Daktronics OmniSport 2000 Timing Console - Manual (Page 124)

106 Diving Mode Operation, Menus & Settings
MENU-TEST
2-SCOREBOARD
SB TEST MENU
1-CYCLE ON/OFF
SB TEST MENU
2-DRI VER ADDRESS
SB TEST MENU
3-DI GI T NUMBER
MENU- TEST
3-JUDGE CONSOLES
Scoreboard Test
These menus check the scoreboard drivers.
Cycle ON/OFF
This menu checks the signal to the scoreboard.
Press [1] to toggle the scoreboard ON and OFF. When this menu is selected, an all ON signal
is sent at intervals of approximately 3 seconds. Press [ENTER] to exit the menu.
Driver Address
This menu shows which addresses each of the drivers on
the scoreboard are set to. The address plugs were inserted
when the display was installed.
Press [2] to display the driver addresses. Press [ENTER] to exit the menu.
Digit Number
This menu displays the digit designation.
Press [3] to display a digit number. The number or letter will show which output on the
driver that digit is plugged into. Press [ENTER] to exit the menu.
Judge Consoles
This menu tests whether or not the judge consoles are
connected to and communicating with the OmniSport 2000
timing console.
The right LCD alternates between the above messages.
From Main Menu – [5]>[2]>[1]
From Main Menu – [5]>[2]>[3]
From Main Menu – [5]>[2]>[2]
From Main Menu – [5]>[3]
From Main Menu – [5]>[2]
DI SPLAY ALL ON
ENTER TO EXI T
SHOWI NG ADDRESS
ENTER TO EXI T
SHOWI NG DI GI T #
ENTER TO EXI T
JUDGE CONSOLE
TESTI NG MODE N=NEAR F=FAR
?= NOT CONNECTED