Daktronics OmniSport 2000 Timing Console - Manual (Page 265)

OmniSport 2000, Pro Swimming, & Hy-Tek Software Quick Guide 5 of 6
ED-13876 Rev 5
19 August 2013
201 Daktronics Drive PO Box 5128, Brookings, SD 57006-5128
Tel: 1-800-DAKTRONICS (1-800-325-8766) Fax: 605-697-4746
Web: www.daktronics.com/support
MEET MANAGER Timing Console Interface Setup
1. From the main menu of MEET MANAGER, go to Set-up >
Timing Console INTERFACE.
2. In the Timer Vendor window, select Daktronics OmniSport 2000.
3. Under Connection Method- OmniSport 2000 Only, select UDP Ethernet.
4. Click OK to save the settings.
MEET MANAGER & OmniSport 2000 Communication
1. From the main menu of MEET MANAGER, click Run.
2. In the Run the Meet window, go to Interfaces > Timer (DAK2) >
Set UDP IP Address.
3. In the Select Set UDP IP
Address window, verify the IP
address of the OmniSport
console and click OK. The
default addresses are as
shown in the table at right:
4. Go to Interfaces > Timer (DAK2) > Test Communication with
DAK2. If all connections and configurations are correct, the
Communications Passed message appears with the version of
firmware in the OmniSport 2000 console. Click OK.
Name IP Address
OMNI1 192.168. 0. 55
OMNI2 192.168. 0. 56
OMNI3 192.168. 0. 57
OMNI4 192.168. 0. 58