Daktronics OmniSport 2000 Timing Console - Manual (Page 120)

102 Diving Mode Operation, Menus & Settings
MENU-COMM PORTS
2-RTD PORT
MENU-COMM PORTS
3-RESULTS PORT
MENU-PRI NTER
1-DI VE LOG
RTD Port
Select RTD Port to assign a protocol, Real-Time Data (RTD)
or Colorado Timing System (CTS), to transmit out of the J5
RTD PORT on the console.
Use [←][→] to select RTD (default) to send information to a Daktronics display controller or
CTS to send to a numeric CTS scoreboard, and then press [ENTER] to save.
Results Port
Select Results Port to assign a protocol to transmit out of the
J6 RESULTS PORT on the console to communicate with
meet management software.
OmniSport 2000 (default) and OmniSport 6000 are bi-directional protocols. CTS is a
unidirectional protocol, utilizing the standard CTS scoreboard information.
Use [←][→] to select OMNI 2000, OMNI 6000, or CTS, depending on what the meet
management software is expecting to receive, and then press [ENTER] to save.
Note: Selecting Omni 6000 transmits Omni 6000 RTD item numbers on the RTD output.
7.14 Setup Printer Menu
This menu offers the following submenus to set the type of
printouts desired.
Dive Log
This menu allows logging to be turned ON/OFF.
Typically the Dive Log is ON.
Use [←][→] to toggle between ON/OFF and then press [ENTER]
to save.
When to use this:
 Using the Dive Log is the most thorough way to
identify issues with the system. Daktronics recommends
that the Dive Log is always turned on. As scores are
accepted, the printer will print the results (Figure 104).
Figure 104: Dive Log Printout
From Main Menu – [4]>[3]>[2]
From Main Menu – [4]>[3]>[3]
From Main Menu – [4]>[4]
From Main Menu – [4]>[4]>[1]
MENU-COMM PORTS
RTD PORT: RTD* MENU-COMM PORTS
RTD PORT: CTS*
COMM PORTS
RSLT: OMNI 2000*
MENU-SETUP
4-PRI NTER
MENU-PRI NTER
DI VE LOG: ON*