Daktronics OmniSport 2000 Timing Console - Manual (Page 305)

Console & Software Revision History 253
Pace Clock
 Corrected a problem with all lines of the scoreboard not being updated properly on a
Reset All operation.
Synchronized Swimming
 Added receive of the RTD Offset and Display Dimming packets from the Pro
Synchronized Swimming application.
Water Polo
 Made a correction in the Reset operation not setting the step back to TIME from a
REST step. Also, set the game time to an OVER value when the period number was
greater than 4 instead of a PERIOD value.
 Made an addition to the PERIOD and PERIOD +1 operations so that they were
invalid during a REST step.
 Changed the title in the Timer Menu from AUTO RUN to AUTO SEQUENCE to
better indicate the operation of the timer.
 Added a Print Menu and a selection to print the current settings from the menu.
Track
 Added the ability to transmit the finish times to a Meet Manager application for heats
that were timed using the Lane, Place, and Non-Lane timing modes of the timer.
 Added the ability to automatically force another Store/Print operation upon reset of
the timer when various operations (such as Edit, DQ, etc.) are performed after the
initial Store/Print. This helps assure that the current race information is properly
stored in memory and available for retrieval by the Meet Manager application.
 Added a selection for showing the DQ status only or the DQ status along with the
split/finish times on the Numeric and RTD/Matrix scoreboards.
 Added the ability to resume the paging of finish times for all of the lanes that have a
valid finish time upon reset of the timer. Previously, the paging would stop if all of
the unused lanes were not turned off.
 Added the ability to show '0.00' for the running time on single line scoreboards upon
reset of the timer when the Finish Page Time is set to a value of zero (0). Before, the
scoreboard would show the first place runner until the start of the next race.
Version 9.10.13 - Release date: 13 October 2009
General
 Corrected problem with sending data on the scoreboard outputs using the Multiline
and Omega protocols.
Swimming
 Corrected problem with transferring a maximum length event order between the
timer and Pro application.
 Corrected problem with the Version Message not always being sent to the Pro
application.
Version 11.7.20 – Release date: 20 July 2011
Diving
 Added support of 11 judge consoles for Synchronized Diving.
Version 12.2.8 – Release date: 8 February 2012
General
 Changed the default protocol to Multidrop for the Scoreboard Outputs.
 Changed the maximum Broadcast Group from 2 to 8 for the radio functions to
support Gen V and VI.
 Adjusted timing parameters for control of LCD.