Daktronics OmniSport 2000 Timing Console - Manual (Page 37)

General Console Features & Operation 19
5. Place the newly cut squared edge of the paper into the
back side of the black rubber roller on the printer. The
printer should automatically advance—pulling the
paper through the printer.
6. Place the cover back on and turn the latch to secure.
The thermo printer paper can be ordered from Daktronics—
part # SF-1034. Thermo printer paper is also readily available
at office supply stores (58mm wide and 165' long max).
3.4 OmniSport 2000 Console Startup
After all connections are made, power on the OmniSport 2000 timer. Initially the LCDs
confirm the product, the version and software identification as illustrated below.
Use [↑][↓] on the console to select the desired sport, and then press [Enter].
If the timing console includes a radio, read Section 3.5. If the console does not, skip to
Section 3.6 on how to receive software updates from Daktronics. For further explanations on
swimming, diving and water polo timing console operations refer to Section 4-Section 10.
3.5 Setting Radio Channels on Wireless Consoles
Reference Drawings:
Channel Selection; Multiple Broadcast Group, Gen IV .......................... Drawing A-203113
Installation Details, Gen VI Channel Selection Guide .......................... Drawing A-1109870
The radio receiver units used in Daktronics scoreboards have a channel (CHAN) switch that
can be set from 1–8. The receivers also have a broadcast group (BCAST) setting. The
broadcast group defines a group of radio receivers that “listen” to the channel selected on the
channel switch as well as “listen” for data sent out on their broadcast channel.
Figure 50: Incorrect Paper Feed
OMNI SPORT 2000
TI MI NG CONSOLE
VERSI ON 13.07.08
ED-12914
DAKTRONI CS, I NC
BROOKI NGS SD
SELECT TI MER
NAME: OMNI -1
ENTER TI ME: 24hr
TI ME hh:mm:ss *
SELECT SPORT
1-SWI MMI NG
ENTER DATE:
DATE mm/dd/yy *
In most cases, the timer name should be set to “OMNI-1”.
Selecting a different name sets the console to a specific IP
address when there are multiple consoles on a network
(up to 4). Use [↑][↓] to change the name as needed, and
then press [ENTER] to continue.
Using the numeric keypad, enter the date and then then
press [ENTER]. Enter time of day in 24 hour format and
then press [ENTER]. The date and time appears on each
event printed from the OmniSport 2000 console.
Note: If the current date/time is not set and the
console is connected to the Pro software, the console
will take the computer’s date and time.)