Daktronics OmniSport 2000 Timing Console - Manual (Page 304)

252 Console & Software Revision History
 Added the ability to transmit Multicast protocol on the Scoreboard Outputs to
support the next generation of numeric scoreboards.
 Increased the levels of dimming from 3 to 9 for the Multidrop and Multicast
protocols.
 Added an Automatic/Manual dimming mode for the Multicast protocol.
 Added the ability to select 12 hour or 24 hour format when displaying the Time of
Day on the numeric scoreboards.
 Added the ability to send the Home, Guest 1, Guest 2, and Guest 3 team scores on the
RTD port for swimming, diving, and track.
 Added the ability to send RTD at an offset (5K, 10K, 15K) other than 0 for the
remaining sports.
 Corrected a small problem in Scoreboard On/Off operation where the blanking of
the RTD was done at an offset of 0 only (ignored the RTD Offset setting).
 Made a slight modification to the method for updating a CTS output to ensure better
compatibility with a Colorado Time matrix controller.
Swimming
 Changed the criteria for setting the initial arming delays on the near end and far end
touchpad inputs for a normal start by an external starting device, Always Ready Start
operation for a missed start signal, and if the operator manually edits the start time.
 Reduced the default arm time for the RTOP window from 1.0 to 0.8 seconds.
 Made a correction to the ARM TIME window for the RTOP. Positive relay exchanges
at or near to the value ARM TIME were not being recorded.
 Added the ability to determine the source (main or store/print dialogue) of the Lane
On/Off command from the Pro application so that the correct operation is performed
on the timer.
 Added the ability to automatically force another Store/Print operation upon reset of
the timer when various operations (such as Edit, DQ, etc.) are performed after the
initial Store/Print. This helps assure that the current race information is properly
stored in memory and available for retrieval by the Meet Manager application.
 Corrected a problem with a negative lane number being generated for REVERSE
ORDER setting on extra lane modules connected to the timer and invalid data being
sent to the Pro Swim application.
 Added a selection for showing the Start Reaction times on the Numeric scoreboards.
 Added a selection for showing the DQ status only or the DQ status along with the
split/finish times on the Numeric and RTD/Matrix scoreboards.
 Added the ability to resume the paging of finish times for all of the lanes that have a
valid finish time upon reset of the timer. Previously, the paging would stop if all of
the unused lanes were not turned off.
 Added the ability to show '0.00' for the running time on single line scoreboards upon
reset of the timer when the Finish Page Time is set to a value of zero (0). Before, the
scoreboard would show the first place swimmer until the start of the next race.
 Added an "Official Results" field to the Enhanced RTD that is set when the Swap
Order button is selected on the Pro Swim application.
Diving
 Corrected a problem of the Total Score not printing properly when the judge scores
were accepted on the Pro application and the value exceeded 255 points
 Added receive of the RTD Offset and Display Dimming settings from the Pro Dive
application.
 Added control of additional CTS modules to drive a CTS matrix display.