Interlogix GE-DSSG-244-POE User Manual - Manual (Page 79)

IFS NS3601-24P/4S GE-DSSG-244 and 244-POE User Manual
77
•
Flow Control
When Auto Speed is selected for a port, this section indicates the flow control
capability that is advertised to the link partner.
When a fixed-speed setting is selected, that is what is used.
Current Rx column indicates whether pause frames on the port are obeyed.
Current Tx column indicates whether pause frames on the port are transmitted.
The Rx and Tx settings are determined by the result of the last Auto-Negotiation.
Check the configured column to use flow control.
This setting is related to the setting for Configured Link Speed.
• Maximum Frame Enter the maximum frame size allowed for the switch port, including FCS. The
allowed range is 1518 bytes to 9600 bytes.
• Excessive Collision
Mode
Configure port transmit collision behavior.
Discard
: Discard frame after 16 collisions (default).
Restart : Restart back off algorithm after 16 collisions.
• Power Control The Usage column shows the current percentage of the power consumption per
port. The Configured column allows for changing the power savings mode
parameters per port.
Disabled
: All power savings mechanisms disabled.
ActiPHY : Link down power savings enabled.
Dynamic : Link up power savings enabled.
Enabled : Link up and link down power savings enabled.
When set each port to run at 100M Full, 100M Half, 10M Full, and 10M Half-speed modes. The
Auto-MDIX function will disable.
Buttons
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved values.
: Click to refresh the page. Any changes made locally will be undone.
Port Statistics Overview
This page provides an overview of general traffic statistics for all switch ports. The ports belong to the currently selected stack unit,
as reflected by the page header. The Port Statistics Overview screen is shown
Figure 4-4-2 .