Interlogix GE-DSSG-244-POE User Manual - Manual (Page 220)

IFS NS3601-24P/4S GE-DSSG-244 and 244-POE User Manual
218
The page includes the following fields:
Object Description
• Mode of IP Source
Guard Configuration
Enable the Global IP Source Guard or disable the Global IP Source Guard. All
configured ACEs will be lost when the mode is enabled.
• Port Mode
Configuration
Specify IP Source Guard is enabled on which ports. Only when both Global Mode
and Port Mode on a given port are enabled, IP Source Guard is enabled on this
given port.
• Max Dynamic Clients Specify the maximum number of dynamic clients can be learned on given ports.
This value can be 0, 1, 2 and unlimited. If the port mode is enabled and the value
of max dynamic client is equal 0, it means only allow the IP packets forwarding
that are matched in static entries on the specific port.
Buttons
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved values.
IP Source Guard Static Table
This page provides Static IP Source Guard Table. The Static IP Source Guard Table screen is shown Figure 4-12-11 .
Figure 4-12-11 Static IP Source Guard Table screen page screenshot
The page includes the following fields:
Object Description
• Delete Check to delete the entry. It will be deleted during the next save.
• Port The logical port for the settings.
• VLAN ID The VLAN ID for the settings.
• IP Address Allowed Source IP address.
• IP Mask It can be used for calculating the allowed network with IP address.
Buttons
: Click to add a new entry.
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved values.