Interlogix GE-DSSG-244-POE User Manual - Manual (Page 21)

IFS NS3601-24P/4S GE-DSSG-244 and 244-POE User Manual
19
■ Reset button
On the left hand side of the front panel, the reset button is designed for rebooting the Managed Switch without a power cycle.
The following is the summary table of Reset button functions
:
Reset Button Pressed and Released Function
< 5 sec : System reboot Reboot the Managed Switch
> 10 sec : Factory Default
Reset the Managed Switch to Factory Default configuration.
The Managed Switch will then reboot and load the default
settings as below:
。 Default Username: admin
。 Default Password: admin
。 Default IP address: 192.168.0.100
。 Subnet mask: 255.255.255.0
。 Default Gateway: 192.168.0.254
■ Stack ID
Each IFS Managed Stackable Switch on a stack must have a unique “Stack ID”. There are 16 degrees (0~9, A~F) in the rotary
switch. The Stack ID is configured via Web or CLI management interface. Use the Stack ID to identify the location of the real
device.
Stack ID is not equal to the Master Priority that is configured in the management interface.
■ Master LED
If master switch fails or is disconnected to the switch by stack port, the switch with lowest switch ID will become the master.