Interlogix GE-DSSG-244-POE User Manual - Manual (Page 361)

User’s Manual of NS3601-24P/4S Series
359
: This field shall contain the DSCP value to be used to provide Diffserv node behavior for the specified
application type as defined in IETF RFC 2474 [5]. This 6 bit field may contain one of 64 code point
values (0 through 63). A value of 0 represents use of the default DSCP value as defined in RFC 2475.
LLDPMED Port Policy
Description:
Set or show LLDP-MED port polcies.
Syntax:
LLDPMED port policies [] []
Parameters:
: Port list or 'all', default: All ports
: List of policies to delete
LLDPMED Coordinates
Description:
Set or show LLDP-MED Location.
Syntax:
LLDPMED Coordinates [latitude|longitude|altitude] [north|south|west|east|meters|floor] [coordinate_value]
Parameters:
latitude : Latitude, 0 to 90 degress with max. 4 digits ( Positive numbers are north of the equator and negative
numbers are south of the equator).
longitude : Longitude,0 to 180 degress with max. 4 digits ( Positive values are East of the prime meridian and
negative numbers are West of the prime meridian.
altitude : Altitude, Meters or floors with max. 4 digits.
(default: Show coordinate location configuration)
north|south|west|east|meters|floor:
North
: North (Valid for latitude)
South : South (Valid for latitude)
West : West (Valid for longitude)
East : East (Valid for longitude)
Meters : Meters (Valid for altitude)
Floor : Floor (Valid for altitude)
lldpmed Coordinate value
coordinate_value
: lldpmed Coordinate value
LLDPMED Datum
Description:
Set or show LLDP-MED Coordinates map datum.
Syntax:
LLDPMED Datum [wgs84|nad83_navd88|nad83_mllw]
Parameters:
wgs84|nad83_navd88|nad83_mllw:
wgs84
: WGS84
nad83_navd88 : NAD83_NAVD88
nad83_mllw : NAD83_MLLW
lldpmed Coordinate datum
LLDPMED Fast
Description:
Set or show LLDP-MED Fast Start Repeat Count.
Syntax: