Interlogix GE-DSSG-244-POE User Manual User Manual
Page 23
IFS NS3601-24P/4S GE-DSSG-244 and 244-POE User Manual
21
Per 10/100/1000Base-T port / SFP interfaces
LED
Color
Function
Illuminates:
To indicate the link through that port is successfully established with speed
1000Mbps.
Blink
:
To indicate that the Switch is actively sending or receiving data over that port.
1000
LNK/ACT
Green
Off:
If 10/100 LNK/ACT LED is light, it indicates that the port is operating at
10Mbps or 100Mbps. If LNK/ACT LED is Off, it indicates that the port is link
down.
Illuminates:
To indicate the link through that port is successfully established with speed
10Mbps or 100Mbps.
Blink
:
To indicate that the Switch is actively sending or receiving data over that port.
10/100
LNK/ACT
Green
Off:
If 1000 LNK/ACT LED is ON, it indicates that the port is operating at
1000Mbps.
If 1000 LNK/ACT LED is Off, it indicates that the port is link down.
1. Press the RESET button for
5 seconds
. The Managed Switch will reboot automatically.
2. Press the RESET button for
10 seconds
. The Managed Switch will restore back to the factory default
mode; the entire configuration will be erased.
3. The 2 Gigabit TP/SFP combo ports are shared with port 25/26 of Managed Switch. Either of them can
operate at the same time.
GE-DSSG-244 LED indication
Figure 2-4
GE-DSSG-244 LED panel
■ System
LED
Color
Function
PWR
Green
Illuminates
to indicate that the Switch is powered on.
Blink
to indicate the System is running under booting procedure.
Master
Green
Illuminates
to indicate that the Switch is the Master of the stack group
STX1
Green
Illuminates
to indicate the stacking link through that port is successfully established.
STX2
Green
Illuminates
to indicate the stacking link through that port is successfully established.