Interlogix GE-DSSG-244-POE User Manual - Manual (Page 70)

IFS NS3601-24P/4S GE-DSSG-244 and 244-POE User Manual
68
„ System Information The system information is provides here.
„ Trap Configuration Configure SNMP trap on this page.
„ SNMPv3 Communities Configure SNMPv3 communities table on this page.
„ SNMPv3 Users Configure SNMPv3 users table on this page.
„ SNMPv3 Groups
Configure SNMPv3 groups table on this page.
„ SNMPv3 Views
Configure SNMPv3 views table on this page.
„ SNMPv3 Accesses
Configure SNMPv3 accesses table on this page.
SNMP System Configuration
Configure SNMP on this page. The SNMP System Configuration screen is shown Figure 4-3-1 .
Figure 4-3-1 SNMP System Configuration page screenshot
The page includes the following fields:
Object Description
•
Mode
Indicates the SNMP mode operation. Possible modes are:
Enabled
: Enable SNMP mode operation.
Disabled : Disable SNMP mode operation.
•
Version
Indicates the SNMP supported version. Possible versions are:
SNMP v1
: Set SNMP supported version 1.
SNMP v2c : Set SNMP supported version 2c.
SNMP v3 : Set SNMP supported version 3.
•
Read Community Indicates the community read access string to permit access to SNMP agent.
The allowed string length is 0 to 255, and the allowed content is the ASCII
characters from 33 to 126. The field only suits to SNMPv1 and SNMPv2c.
SNMPv3 is using USM for authentication and privacy and the community string
will associated with SNMPv3 communities table.
•
Write Community
Indicates the community write access string to permit access to SNMP agent.
The allowed string length is 0 to 255, and the allowed content is the ASCII
characters from 33 to 126. The field only suits to SNMPv1 and SNMPv2c.
SNMPv3 is using USM for authentication and privacy and the community string
will associated with SNMPv3 communities table.
•
Engine ID Indicates the SNMPv3 engine ID. The string must contain an even number
between 10 and 64 hexadecimal digits, but all-zeros and all-'F's are not allowed.
Change of the Engine ID will clear all original local users.
Buttons
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved values.