Interlogix GE-DSSG-244-POE User Manual - Manual (Page 157)

IFS NS3601-24P/4S GE-DSSG-244 and 244-POE User Manual
155
•
Shaper Enabled
Enable or disable the port shaper. The default value is "Disabled".
• Shaper Rate Configure the rate for the port shaper. The default value is "500". This value is
restricted to 500-1000000 when the "Policer Unit" is "kbps", and it is restricted to
1-1000 when the "Policer Unit" is "Mbps"
• Shaper Unit Configure the unit of measure for the port shaper rate as kbps or Mbps. The
default value is "kbps".
Storm Control Configuration
Storm control for the switch is configured on this page. There three types of storm rate control:
„ Unicast storm rate control
„ Multicast storm rate control
„ Broadcast storm rate control.
The rate is 2^n, where n is equal to or less than 15, or "No Limit". The unit of the rate can be either pps (packets per second) or kpps
(kilopackets per second). The configuration indicates the permitted packet rate for unicast, multicast, or broadcast traffic across the
switch. The Storm Control Configuration screen is shown
Figure 4-9-11.
Figure 4-9-11 Storm Control Configuration page screenshot
The page includes the following fields:
Object Description
•
Frame Type The settings in a particular row apply to the frame type listed here:
unicast
multicast
broadcast
•
Status
Enable or disable the storm control status for the given frame type.
•
Rate
The rate unit is packet per second (pps), configure the rate as 1, 2, 4, 8, 16, 32,
64, 128, 256, 512, 1K, 2K, 4K, 8K, 16K, 32K, 64K, 128K, 256K, 512K, or 1024K.
The 1 kpps is actually 1002.1 pps.
Buttons
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved values.
QoS Statistics
This page provides statistics for the different queues for all switch ports. The ports belong to the currently selected stack unit, as
reflected by the page header. The QoS Statistics screen is shown
Figure 4-9-12 .