Vlan setting example, Two separate 802.1q vlan – Interlogix GE-DSSG-244-POE User Manual User Manual
Page 108

IFS NS3601-24P/4S GE-DSSG-244 and 244-POE User Manual
106
VLAN setting example:
- Separate VLAN
- 802.1Q VLAN Trunk
- Port Isolate
Two separate 802.1Q VLAN
The diagram shows how the Managed Switch handle Tagged and Untagged traffic flow for two VLANs. VLAN Group 2 and VLAN
Group 3 are separated VLAN. Each VLAN isolate network traffic so only members of the VLAN receive traffic from the same VLAN
members. The screen is shown
Figure 4-6-8
appears.
Table 4-1
describes the port configuration of the Managed Switches.
Figure 4-6-8
two separate VLAN diagram
VLAN Group
VID
Untagged Members
Tagged Members
VLAN Group 1
1
Port-7~Port-24
N/A
VLAN Group 2
2
Port-1,Port-2
Port-3
VLAN Group 3
3
Port-4,Port-5
Port-6
Table 4-1
VLAN and Port Configuration
The scenario described as follow:
Untagged packet entering VLAN 2
1.
While [PC-1] transmit an untagged packet enters Port-1, the Managed Switch will tag it with a VLAN Tag=2. [PC-2]
and [PC-3] will received the packet through Port-2 and Port-3.
2.
[PC-4],[PC-5] and [PC-6] received no packet.
3.
While the packet leaves Port-2, it will be stripped away it tag becoming an untagged packet.
4.
While the packet leaves Port-3, it will keep as a tagged packet with VLAN Tag=2.
Tagged packet entering VLAN 2
5.
While [PC-3] transmit a tagged packet with VLAN Tag=2 enters Port-3, [PC-1] and [PC-2] will received the packet
through Port-1 and Port-2.
6.
While the packet leaves Port-1 and Port-2, it will be stripped away it tag becoming an untagged packet.