Interlogix GE-DSSG-244-POE User Manual - Manual (Page 72)

IFS NS3601-24P/4S GE-DSSG-244 and 244-POE User Manual
70
Figure 4-3-3 SNMP Trap Configuration page screenshot
The page includes the following fields:
Object Description
•
Trap Mode
Indicates the SNMP trap mode operation. Possible modes are:
Enabled
: Enable SNMP trap mode operation.
Disabled : Disable SNMP trap mode operation.
•
Trap Version
Indicates the SNMP trap supported version. Possible versions are:
SNMP v1
: Set SNMP trap supported version 1.
SNMP v2c : Set SNMP trap supported version 2c.
SNMP v3 : Set SNMP trap supported version 3.
•
Trap Community Indicates the community access string when send SNMP trap packet. The
allowed string length is 0 to 255, and the allowed content is the ASCII characters
from 33 to 126.
•
Trap Destination
Address Indicates the SNMP trap destination address.
• Trap Destination IPv6
Address
Provide the trap destination IPv6 address of this switch. IPv6 address is in
128-bit records represented as eight fields of up to four hexadecimal digits with a
colon separates each field (:). For example, 'fe80::215:c5ff:fe03:4dc7'. The
symbol '::' is a special syntax that can be used as a shorthand way of
representing multiple 16-bit groups of contiguous zeros; but it can only appear
once. It also used a following legally IPv4 address. For example, '::192.1.2.34'.
•
Trap Authentication
Failure
Indicates the SNMP entity is permitted to generate authentication failure traps.
Possible modes are:
Enabled
: Enable SNMP trap authentication failure.
Disabled : Disable SNMP trap authentication failure.
• Trap Link-up and
Link-down
Indicates the SNMP trap link-up and link-down mode operation. Possible modes
are:
Enabled
: Enable SNMP trap link-up and link-down mode operation.
Disabled : Disable SNMP trap link-up and link-down mode operation.
• Trap Inform Mode Indicates the SNMP trap inform mode operation. Possible modes are:
Enabled
: Enable SNMP trap inform mode operation.
Disabled : Disable SNMP trap inform mode operation.
• Trap Inform Timeout
(seconds)
Indicates the SNMP trap inform timeout. The allowed range is 0 to 2147.
• Trap Inform Retry
Times
Indicates the SNMP trap inform retry times. The allowed range is 0 to 255.