Bandwidth control – Interlogix GE-DSSG-244-POE User Manual User Manual
Page 155
IFS NS3601-24P/4S GE-DSSG-244 and 244-POE User Manual
153
•
Default Class
Configure the default QoS class for the port, that is, the QoS class for frames not
matching any of the QCEs in the QCL.
•
QCL #
Select which QCL to use for the port.
•
Tag Priority
Select the default tag priority for this port when adding a Tag to the untagged
frames.
•
Queuing Mode
Select which Queuing mode for this port.
• Queue Weighted
Setting Queue weighted(Low:Normal:Medium:High) if the "Queuing Mode" is
"Weighted".
Buttons
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved values.
Bandwidth Control
Configure the switch port rate limit for Polices and Shapers on this page. The settings relate to the currently selected stack unit, as
reflected by the page header. The screen Bandwidth Control in
Figure 4-9-10
.