Interlogix GE-DSSG-244-POE User Manual - Manual (Page 20)

IFS NS3601-24P/4S GE-DSSG-244 and 244-POE User Manual
18
INSTALLATION
This section describes the hardware features and installation of the Managed Switch on the desktop or rack mount. For easier
management and control of the Managed Switch, familiarize yourself with its display indicators, and ports. Front panel illustrations in
this chapter display the unit LED indicators. Before connecting any network device to the Managed Switch, please read this chapter
completely.
Hardware Description
Switch Front Panel
The unit front panel provides a simple interface monitoring the switch. Figure 2-1 to 2-2 shows the front panel of the Managed
Switches.
GE-DSSG-244 Front Panel
Figure 2-1 GE-DSSG-244 front panel.
IFS NS3601-24P/4S / GE-DSSG-244-POE Front Panel
Figure 2-2 IFS NS3601-24P/4S / GE-DSSG-244-POE front panel.
■ Gigabit TP interface
10/100/1000Base-T Copper, RJ-45 Twist-Pair: Up to 100 meters.
■ Gigabit SFP slots
1000Base-SX/LX mini-GBIC slot, SFP (Small Factor Pluggable) transceiver module: From 550 meters (Multi-mode fiber), up to
10/30/5060//70 kilometers (Single-mode fiber).
■ Console Port
The console port is a DB9, RS-232 male serial port connector. It is an interface for connecting a terminal directly. Through the
console port, it provides rich diagnostic information includes IP Address setting, factory reset, port management, link status and
system setting. Users can use the attached RS-232 cable in the package and connect to the console port on the device. After
the connection, users can run any terminal emulation program (Hyper Terminal, ProComm Plus, Telix, Winterm, etc.) to enter
the startup screen of the device.