IAI America SSEL - Manual (Page 97)

75
Part 1 Installation
Chapter 5 Maintenance
x Routine maintenance and inspection are necessary so that the system will operate properly at all times. Be
sure to turn off the power before performing maintenance or inspection.
x The standard inspection interval is six months to one year. If the environment warrants, however, the interval
should be shortened.
1. Inspection Points
x Check to see if the supply voltage to the controller is inside the specified range.
x Inspect the ventilation holes in the controller and remove dirt, dust and other foreign attachments, if any.
x Inspect the controller cables (controller o actuator) and check for any loose screws or cable
disconnection.
x Check the controller mounting screws, etc., for looseness.
x Inspect each cable (axis link cable, general-purpose I/O cable, system I/O cable, power cable) for loose
connection, disconnection, play, etc.
2. Spare Consumable Parts
Without spare parts, a failed controller cannot be repaired even when the problem is identified quickly. We
recommend that you keep the following consumable parts as spares:
Consumable parts
x Cables
x System-memory backup battery (optional): AB-5 by IAI -- Must be replaced after approx. 5 years
x Absolute-data backup battery (optional): AB-5 by IAI
-- Must be replaced after approx. 2 years*
(Absolute specification)
*: The actual replacement timing will vary depending on the use condition. For details, refer to “
~
Battery Backup Function” in Appendix.
When the battery voltage drops, an applicable error code will be displayed on the panel window.
Error Codes Indicating Low Battery Voltage
System-memory backup battery A01 or A02
Absolute-data backup battery A23