Gasboy CFN III Mgnr's Mnl V3.4 - Manual (Page 69)

MDE-4315 CFN Series CFN III Manager’s Manual for Windows NT · August 2004 Page 53
Tank and Pump Commands
How to Enter Pump-Fill-Limit and Slow-to-Cutoff
The pump limit is the amount the Site Controller will authorize, or request authorization for, if
a customer requests a FILL by pressing that key on the card reader. (If you use privately issued
cards, the limit assigned to the cards will be used instead.)
The pump limit can be in (units/liters) or dollars. Use a dollar sign ($) before the pump-limit
amount to specify a dollar limit.
The slow-to-cutoff point determines how soon before reaching a limit the slow-pump mode is
activated. The slow-to-cutoff point is in gallons prior to the limit.
A default cutoff point and pump limit for all pumps is determined by the Site Controller
configuration. LOAD CUTOFF overrides the default limit. If the default limit is okay for a
pump, you do not need to enter a new limit.
1 Type: LOAD CUTOFF.
2 Enter Pump number.
3 Enter Pump limit.
4 Enter Slow cutoff.
There is also a maximum limit that is set in the Site Controller configuration. You cannot
exceed the Site Controller’s maximum limit with LOAD CUTOFF. You may use the C option
with the command LOAD CUTOFF.
Configure all pumps at once by entering an asterisk for the pump number.
LOAD CUTOFF (LO CU)
P* LOAD CUTOFF
↵
Pump number? 1 ↵
Pump limit? $50
↵
Slow cutoff? .25 ↵
P*