Gasboy CFN III Mgnr's Mnl V3.4 - Manual (Page 39)

MDE-4315 CFN Series CFN III Manager’s Manual for Windows NT · August 2004 Page 23
Remote Access Command Site Controller III
Remote Access Command
SYStem. Typing SYStem will take you to the NT operating system from the CFN3
application. Typing SYS does not change drives, it only allows you to see different drives on
the PC. To return to CFN3 from NT, type EXIT. Do not add any additional extensions or
commands such as SYS PJ or SYS TYPE. It is NOT advised to use this command while using
the PC. When you need to execute NT commands on your PC, use a DOS window with a C:
prompt or use Windows NT Explorer.
This command is designed for use from a remote signon when the PC cannot be accessed
directly.
Optional Commands
Several of the commands shown on the help list, such as DISABLE FPR and ENABLE FPR,
work only with the optional programs you may not have installed. If you try to run these
commands without having installed the program, an error message appears.
The HELP Command
Type HELP to list all valid commands and options for the permission level you are signed on
at. (The short form of the commands are shown in uppercase letters.)
The following illustration shows a printout for a user who has access to all commands. The
number before each command is the number that runs that command from a console.
If you specify the first word of a command with the HELP command, only the commands that
start with that word will be printed. For example, HELP LOAD prints all the commands that
start with LOAD.
If you type HELP * and the second part of a command, you will see all the commands whose
second word starts with what you specified. For example, HELP * VEHICLE (note the blank
space before and after the *) prints all the commands whose second word is VEHICLE.
The A option with the HELP command shows each command prefaced with its command
number.