Gasboy CFN III Mgnr's Mnl V3.4 - Manual (Page 230)

Communications
Page 214 MDE-4315 CFN Series CFN III Manager’s Manual for Windows NT · August 2004
• You may use hyphens and parentheses in the phone number, but they are not required. The
Site Controller ignores the hyphens; they are for your convenience only.
• You may use the C option with the command LOAD PHONE to load both phone numbers.
The phone numbers are set up to dial out through a PBX system. The modem will dial 9
(pulse), wait 2 seconds, then dial the number using tone.
• A single comma separates the command arguments, and two commas enter a 2-second
pause.
How To Print Dial-out Phone Numbers
Use the command PRINT PHONE or P PH to print the dial-out phone numbers that have been
entered. The printout will show whether the phone numbers are for the following:
• the Main (or 1) number and the Backup (or 2) number
• the bank host (Bank)—the 3 and 4 numbers,
• the auxiliary phone number (Aux)—the 5 and 6 numbers
How to Initiate a Call
Dial-out sites call the remote number automatically when they need to get authorization for a
transaction. You can use the command CALL to manually initiate a call.
If the remote modem is down, or if the site is not configured to dial out, the terminal will print
host unavailable when you try to execute CALL. If the connection is never established or is
broken off, the terminal will print Failed.
Kermit
Kermit is a disk-based program for data transfer to another computer, either another SC III or
a PC. A summary of the KERMIT command looks like the following.
P* LOAD PHONE;C M P9,,T543-9974,B,P9,,T543-3245
Phone number?
↵
P*
PRINT PHONE (P PH)
P* PRINT PHONE
↵
Main Backup
CFN P9,T543-9974 P9,T543-3245
P*
CALL
P* CALL
↵
Dialing .... Connected.
P*