Gasboy CFN III Mgnr's Mnl V3.4 - Manual (Page 52)

Receipts, Messages, and Date
Page 36 MDE-4315 CFN Series CFN III Manager’s Manual for Windows NT · August 2004
How to Load Messages
Use the LOad MEssage (LO ME) command in the site controller to load the DPT messages. To
access the 4 lines of the Premier display (or 2 lines for a TCS display), use the tilde character
(~) and the line #1 (1 to 4) before the message. The display times for messages 1 to 3 should be
loaded as 0 seconds; message #4 display time should be greater than 0 seconds. This will allow
the messages on all 4 lines to display at the same time instead of one line at a time.
Note: If more than 4 messages are loaded (5-10), omit the tilde preceding the text for line 4
and the messages will be scrolled in line 4 of the display.
If GASBOY ICRs are on a site along with DPTs, the DPT messages are usually loaded as
described in the previous example. If the GASBOY ICRs will be communicating on the
console loop, the broadcast messages will not be displayed on them. The GASBOY ICRs will
display the message that is on the reader program under step-type 1, which is usually
Slide
card or Insert card .
How to Delete Messages
1 Type: REMOVE MESSAGE.
2 Enter message line number.
You can use the C option with REMOVE MESSAGE.
P* LO ME;C
↵
Message number? 1 ↵
Display in sec? 0
↵
Message? ~1WELCOME TO JOE’S ↵
Message number? 2
↵
Display in sec? 0 ↵
Message? ~2TODAY’S SPECIAL IS
↵
Message number 3: 3 ↵
Display in sec? 0
↵
Message: ~310W30 OIL
↵
Message number? 4 ↵
Display in sec? 9 ↵
Message? ~4HAVE A NICE DAY! ↵
Message number?
↵
P*
REMOVE MESSAGES;C (REM ME;C)
P* REMOVE MESSAGE;C ↵
Message number? 1
↵
Message number? 5 ↵
Message number?
↵
P*