Gasboy CFN III Mgnr's Mnl V3.4 - Manual (Page 229)

MDE-4315 CFN Series CFN III Manager’s Manual for Windows NT · August 2004 Page 213
Communications
20 – Communications
Remote Authorizations
Dial-out Phone Numbers
If your site uses a dial-out line for card-transaction authorization, you need to
enter the remote phone number—and the backup phone number, if there is
one—into the Site Controller. This is for CFN remote verification only. For
bank networks, refer to the specific manual.
How To Enter Dial-out Phone Numbers
Use the command LOAD PHONE or LO PH to enter the remote phone
number(s).
1 Type: LOAD PHONE.
2 Main or Backup? Enter an M or B.
3 Phone number? Enter the phone number.
The main number is the number the Site Controller will call first; the backup
number is the number the Site Controller will call if it does not connect to the
main number.
Usually the main and backup numbers are the same. That way the Site
Controller will try to dial the number again if it does not get through the first
time.
You may specify other information about how the Site Controller is to dial the
phone number:
• Use two commas in the phone number to insert a 2-second pause in dialing.
• Use a P before the phone number to specify pulse dialing, or use a T to
specify tone dialing. If you do not specify P or T, tone dialing will be used.
(If you have a PBX phone system, you may need to first use pulse to obtain
a line out, then switch to tone, which is much faster, to dial the number of
the remote host.)
LOAD PHONE (LO PH)
P* LOAD PHONE
↵
Main (m) or Backup (b)? M ↵
Phone number? 367-6892
↵
P*