Gasboy CFN III Mgnr's Mnl V3.4 - Manual (Page 190)

Using Text Editors
Page 174 MDE-4315 CFN Series CFN III Manager’s Manual for Windows NT · August 2004
How to Set Tab Stops
Use the command-mode TABS n command to set tab stops every n columns. Tabs 0 is
equivalent to tabs 1.
As on a typewriter, TAB is used to move the cursor to the next tab stop. If you print the file,
the spacing will depend on how the printer’s tab stops are set.
How to Edit a New File without Leaving FRED
Use the command-mode LOAD command to edit a new file without leaving the editor. To edit
a new file:
1 If you are not in command mode, type ^C to enter command mode.
2 Use the command SAVE or RESAVE to save the current file that you have been editing.
3 Type
load filename
to edit the new file.
The following page contains the FRED editor command summary.