Gasboy CFN III Mgnr's Mnl V3.4 - Manual (Page 50)

Receipts, Messages, and Date
Page 34 MDE-4315 CFN Series CFN III Manager’s Manual for Windows NT · August 2004
How to Change Heading and Footing Lines
To change one heading or footing line, just use the LOAD HEADING command
to enter new text for that line.
To erase all receipt heading and footing lines and reenter new ones, use the
command LOAD HEADING;IC. The I option erases all current heading and
footing lines and the blank form feed lines at the end. The C option allows you
to enter new heading and footing lines.
How to Delete Heading or Footing Lines
1 Type: REMOVE HEADING.
2 Enter Line number.
You can use the C option.
Island Card Reader Messages
The island card reader messages appear on the reader display while it is
inactive. You can use these as promotional messages, or as instructional
messages that tell your customers how to begin a transaction.
How to Enter Messages
Use the command LOAD MESSAGE or LO ME to enter the messages. The
number of messages allowed is determined by the Site Controller configuration;
20 is the default number allowed. Each message can be up to 20 characters long.
For a blank display, press the space bar and ENTER after Message to display?.
A single comma terminates an item, so to use a comma in your message, you
must type two commas. At this time, curly braces are reserved characters and
are not to be used in messages. They are no longer used to allow text to flash or
blink on the reader.
Display Multiple Lines
To display multiple lines, use the C option with the command LOAD
MESSAGE. Enter each line separately and specify the display time.
REMOVE HEADING (REM H)
P* REMOVE HEADING
↵
Line number? 2 ↵
P*