Gasboy CFN III Mgnr's Mnl V3.4 - Manual (Page 38)

Site Controller III Redirecting Command Input and Output
Page 22 MDE-4315 CFN Series CFN III Manager’s Manual for Windows NT · August 2004
How to Pause Printout
A pause in printing is useful for viewing a printout on a CRT.
To temporarily pause printing without terminating a command, enter a ^S (S for stop) or press
the PAUSE key if you have a printer terminal. This will keep new lines from being printed.
To continue printing, enter a ^Q, or press ENTER, or press the PAUSE key again.
How to Pause Printout with the L Option
Use the L option to automatically pause printing after a specified number of lines have been
printed. Press ENTER to print the next group of lines. If you do not specify a number, 24 lines
will be printed.
To use the L option to specify page length, type a semicolon L (;L), followed by an equals sign
and the desired number, after the command. For example, ;L=20 sets the screen length to 20
lines.
The L option will affect all subsequent print commands until you sign off. To remove the L
option, type semicolon L=0 (;L=0) or semicolon minus L (;-L) after a command.
• Type: PRINT DIAGNOSTICS;L
The terminal will print 24 lines each time the user presses ENTER, until all the diagnostics
have been printed
• Type: PRINT DIAGNOSTICS;L=20
The terminal will print 20 lines each time the user presses ENTER, until all the diagnostics
have been printed
Permission Levels
Permission levels are used for security and safety. By assigning appropriate permission levels
to users and to commands, you can make sure that users have access to only the commands
they need to use.
In the default configuration, users with permission level 2 are allowed to activate only basic
CFN3 commands. Users with permission level 10 are allowed to activate all CFN3 commands.
P* PRINT DIAGNOSTICS;L
P* PRINT DIAGNOSTICS;L=20