Gasboy CFN III Mgnr's Mnl V3.4 - Manual (Page 63)

MDE-4315 CFN Series CFN III Manager’s Manual for Windows NT · August 2004 Page 47
Tank and Pump Commands
Type: PRINT PRICE.
To specify price codes to display, enter the code number at the command.
How to Enter Price Code Levels and Prices
Use the command LOAD PRICE or LO PR to enter price levels and prices for
price codes. The number of price levels and prices allowed is determined by the
Site Controller configuration.
If you are changing prices while the site is open for business, first shut down
the site with the command STOP. This will allow transactions in progress to
finish, but prevent new transactions from starting while you are changing
prices. When you have finished changing prices, use the command RUN to
restart the site.
How to Change Price-code Prices
It is a good idea to write down or print existing prices before making changes,
and again after making changes to check your work.
To change prices for a price code, use LOAD PRICE or LO PR to enter new
prices for the price levels for that price code.
There are two methods for changing prices for price codes.
The first method is to enter the new price for each price code and price level
that you wish to change. This method uses LOAD PRICE;C command.
PRINT PRICE (P PR)
P* PRINT PRICE
↵
Pc Pl Price
1 0 1.169 1 1.169 2 1.199
2 0 1.229 1 1.229 2 1.299
3 0 1.299 1 1.299 2 1.306
P*
P* PRINT PRICE 1 ↵
Pc Pl Price
1 0 1.169 1 1.169 2 1.199
P*
LOAD PRICE (LO PR)
P* LOAD PRICE
↵
Price code? 2
↵
Price level? 1 ↵
Price? 1.119
↵
Price level?
↵
P*