INFICON HAPSITE Smart Plus Chemical Identification System - Manual (Page 66)

2 - 28
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
5 The white label THIS END TO ACCESSORY on the insulation should coincide
with the white label THIS END TO ACCESSORY on the Transfer Line. See
Figure 2-24 . When alignment is correct, slide the insulation into place.
Figure 2-45 Accessory End of the Transfer Line
6 Install the Transfer Line between the HAPSITE and the SituProbe. First,
disconnect the Probe from the HAPSITE. Install the LEMO connector, which is
labeled, THIS END TO HAPSITE, in the HAPSITE connector. The opposite end
labeled, THIS END TO ACCESSORY, will connect to the rear of the SituProbe.
See
Figure 2-46 . Make sure the red dots on the Transfer Line connectors align
with the marks on the HAPSITE and SituProbe connectors.
Figure 2-46 Attaching the Transfer Line to the HAPSITE