INFICON HAPSITE Smart Plus Chemical Identification System - Manual (Page 233)

5 - 27
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
5.7.2 Quick Reference SOP — Analyze Mode with SituProbe
1 Double-click the Plus IQ software icon.
2 Verify that the desired sample configuration (i.e., Sample Loop or
Concentrator) is installed.
3 Make sure the SituProbe is set-up properly. See Section 2.9, SituProbe, on
page 2-27 for assembly information.
4 If necessary, power on the HAPSITE or take the system out of Extended
Standby.
5 Depending upon the method, the HAPSITE will begin preparing the
Concentrator. If needed, see
Section 3.1.2, Concentrator Options (CONC
OPTIONS), on page 3-8 . See Section 5.3, Selecting a New Method, on page
5-7 if the start up method is not the desired method
6 When the system has finished preparing, click the RUN METHOD icon. Select
the desired method from the appropriate folder. Refer to Steps 2-4 of
section
5.3 on page 5-7 .
7 Click the Run button in the pop-up window.
8 When the screen prompts, Collect Sample Now and Sampling Is Done, no
action is required from the user.
9 When the run is complete, a Method Finished prompt will appear.
10 To analyze the data, see Chapter 9, Data Review .