INFICON HAPSITE Smart Plus Chemical Identification System - Manual (Page 219)

5 - 13
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
Figure 5-17 Sample Complete
12 Review results at the end of the run.
13 To view the data, note the data file name and click on the Data Review icon in
the Setup System window of the Plus IQ software. See
Figure 5-18 .
Figure 5-18 Data Review Icon
14 Select the Loop folder and locate the data file that was just run. Full instructions
for data review are found in
Chapter 9, Data Review .
NOTE: If the HAPSITE has been left unattended, the message SYSTEM IS NOT
READY may appear. To begin preparing the system again, either touch
PREPARE or using the arrow keys, highlight PREPARE and push OK
SEL.