INFICON HAPSITE Smart Plus Chemical Identification System - Manual (Page 254)

7 - 12
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
Show Tune Status Panel . . . . . . . . Displays the Tune and Mass Calibration
Status panel.
Show Mass Calibration Status . . . Displays the Mass Calibration Status panel.
View Tune Reports . . . . . . . . . . . . . Displays the Tune Reports screen.
Properties . . . . . . . . . . . . . . . . . . . . Displays the Properties window, which is
used to set the default screen display and
startup/exit conditions for Manual Tune. See
Figure 7-16 .
Advanced . . . . . . . . . . . . . . . . . . . . Displays the Advanced tune functions.
Linearize DACS. . . . . . . . . . . . . Repositions the tune gas mass peaks on the
mass axis by linear extrapolation of the
digital to analog control settings.
AutoTune Tolerances . . . . . . . . Sets the AutoTune tolerance for mass
resolution and mass axis position.
NOTE: The Advanced functions should only be used under the direction of
INFICON Support personnel.
7.5.2.1 Tune Properties Window
Figure 7-16 Tune Properties Window
Show Tune Parameters . . . . . . . . . Displays the EM Voltage, Ionizer control,
Baseline, Threshold and Rod polarity
settings on the Control Panel
Show Mass Tune Controls. . . . . . . Displays the Mass Tune Controls on the
Mass Peak Scan windows.
Show Control Panel . . . . . . . . . . . . Displays the Control panel.
Common Scale . . . . . . . . . . . . . . . . Sets the Mass Peak Scan windows to a
common scale based on mass 117.