INFICON HAPSITE Smart Plus Chemical Identification System - Manual (Page 457)

13 - 19
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
13.5 Charging the HAPSITE Battery using the HSS
HAPSITE batteries may be charged one at a time using the HSS.
To charge a battery, connect the HSS to remote power using the AC-to-24 V(dc)
adapter. Turn on the HSS by pressing the power toggle switch inside the front door.
Insert the battery to be charged into the battery compartment, with the lettering
right-side-up, until the battery is engaged.
Leave the HSS power on until the battery is fully charged. The battery should take
approximately 12 hours to fully charge. The approximate level of the battery’s
charge can be monitored by pressing the TEST button on the battery. The battery
level is indicated in 20% increments. Refer to
section 2.12, Batteries, on page 2-47
for additional information on batteries.