INFICON HAPSITE Smart Plus Chemical Identification System - Manual (Page 389)

11 - 29
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
11.7 Full Scan Page
WARNING
Only trained users should modify methods. Changing
parameters may result in incorrect analysis.
The Full Scan page contains the mass range and other parameters of the Mass
Spectrometer operation (see
Figure 11-24 ). The full parameter set can be assigned
a Scan Set Name for easy identification, if desired. The Filament Delay, from the
Inlet Page (see
section 11.5.4, Scan Events, on page 11-23 ), is also shown on the
Full Scan page. Changing the Filament Delay on this page may require a review
of, and changes to, the Inlet Page.
Figure 11-24 Method Editor Full Scan Page
The following Mass Spectrometer parameters can be programmed: